Engine
Disassembly and Assembly
Turbocharger (AiResearch
T04)
NOTICE
The snap rings must be installed with the rounded
outside edge toward the bearing.
2.
Install the Inner snap ring, bearing (1) and snap ring
(2) in each side of the housing.
3.
Install the seal ring on collar (4).
4.
Put bearing (3) in position on the collar.
NOTICE
The oil grooves in the bearing must be clean and
free of all dirt or foreign material. The bearing must
be installed with the oil grooves toward the housing.
5.
Put the bearing and collar in position on the housing
so the oil grooves in the bearing are toward the housing
and the holes in the bearing are in alignment with the
pins in the housing.
NOTICE
Be extra careful during installation of the bearing
and collar not to cause damage to the seal ring on
the collar.
6.
Install the seal ring on the housing.
7.
Put the backplate assembly in position on the
housing respective to the alignment marks put on the
housing and backplate at disassembly. Install the plates
and bolts. Tighten the bolts to a torque of 8.5 to 10.2
Nom (75 to 90 Ib.in.).
54
