• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure   2-58.   Power   Supply
DIESEL  HEATERS.

TM-10-4610-232-34 Water Purification Unit Reverse Osmosis 3 000 GPH Trailer Mounted Flatbed Cargo 22-1/2 Ton 8 Wheel Tandem Model No. WTA-060 Manual
Page Navigation
  199    200    201    202    203  204  205    206    207    208    209  
TM    10-4610-232-34 R  E  P  A  I  R  .   a. b. c. d. Replace any damaged or missing components. Replace  loose  or  damaged  ring  tongue  connectors  (para.  4-10,  TM  10-4610-232-12) Replace  missing  or  damaged  wire  markers  (para.  4-10,  TM  10-4610-232-12). Repair cables in accordance with para. 2-7. REASSEMBLY. a. Install terminal board (33) and secure with screws (32). b. Install EMP modules (29 and 30) and secure with screws (31). c. Install all wires (27) at terminal board (33) and EMP modules (29) as tagged. d. Install cables (1, 2, 3 and 4) as follows: (1) Slide nuts (1 5), retainers (16) and bushing (17) on each cable. (2) Place sealing washer (20) on each connector body (19)and secure in power SUPPIY(10) with conduit nuts (18). (3) Insert the cable through body (19) into the power supply. Tighten nut (15) to secure the cable to the power supply. (4) Connect the wires from each cable to terminal board (33) as tagged. e. Slide nut (21), retainer (22) and bushing (23) onto cable (5). Install sealing washer (26) onto elbow (25) and into power supply (10). Secure with conduit nut (24). f. Insert cable (5) through elbow (25). Tighten nut (21). g. Connect cable wires to terminal board (33) as tagged. h. Install cover (14) and secure with captive screws (13). INSTALLATION. a. Install mounting bar (12) and secure with socket head screws (11) if removed. WARNING The power supply is heavy. Two people are required to lift it. b. Using two people, lift power supply (10) and secure it to mounting bar (12) with four capscrews (7), lockwashers(8) and washers (9). WARNING Make sure electrical power is disconnected to the unit. Failure to do so could result in serious injury or death. c. Connect cable (5) to power supply (10) as follows: (1) Slide nut (21), retainer (22) and bushing (23) onto cable (5). Install sealing washer (26) onto elbow (25)andinto power supply (1 O). Secure with conduit nut (24). (2) Insert cable (5) through elbow (25). Tighten nut (21). (3) Connect cable wires to terminal board (33) as tagged. (4) install cover (14) and secure with captive screws (13). d.  Reconnect  cable  (5)  to  the  CO  monitor  (para.  4-63,  TM  10-4610-232-12). e.  Reinstall  all  tie  wraps  (6)  which  were  removed  (para.  4-10,  TM  10-4610-232-12). f. Reconnect cables (1 thru 4). 2-186







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.