2-35. TRAILER AIR RESERVOIR ASSEMBLY. (Figure 2-29) (ARMY)
TM 10-4610-215-24
TM 08580A-24/2
a. Removal.
(1) Disconnect tubing (1) from tube fitting (2).
(2) Remove nuts (3) and screws (4) attaching reservoir (5) to trailer frame (6).
(3) Remove reservoir (5), tube fitting (1), nipple (2), elbow (3), and drain cock (4) from trailer frame (6) as
a single unit.
b. Disassembly. (Figure 230) If reservoir is to be replaced with a new one, remove tube fitting (1), nipple (2),
elbow (3), and drain cock (4) from reservoir (5).
c. Inspection. Inspect reservoir for dents or other damage. If reservoir is seriously dented or damaged,
replace it.
d. Assembly. (Figure 230) If a new reservoir is to be installed, install elbow (3), nipple (2), tube fitting (1),
and drain cock (4) in reservoir (5).
e. Installation. (Figure 229)
(1) Position reservoir (5), tube fitting (1), nipple (2), elbow (3), and drain cock (4), as a single unit, to trailer
frame (6) .
(2) Install screws (4) and nuts (3) to attach reservoir (5).
(3) Connect tubing (1) to tube fitting (2).
2-36. TRAILER AIR BRAKE SYSTEM TUBING. (Figure 231 ) (ARMY)
a. Removal.
(1) To remove the sections of tubing between the anchor couplings and the air cleaner assemblies,
perform the following:
(a) Remove nuts (1) and clamps (2) securing tubing (3) to trailer frame (4).
(b) Disconnect tubing (3) from anchor couplings (5) and air cleaner assemblies (6) by removing nuts
(7) and sleeves (8).
(c) Remove tubing (3), grommets (9), and conduit (10) from trailer frame (4).
(d) Remove grommets (9) and conduit (1) from tubing (3).
(2) To remove the sections of tubing between the air cleaner assemblies and the relay valve (figure 2-32),
perform the following:
(a) Remove nuts (1) and clamps (2) securing tubing (3) to trailer frame (4).
(b) Disconnect tubing (3) from air cleaner assemblies (5) and relay valve (6) by removing nuts (7)
and sleeves (8).
(c) Remove tubing (3), grommets (9), and conduit (10) from trailer frame (4).
(d) Remove grommets (9) and conduit (10) from tubing (3).
2-53