TM 10-4610-229-10
2-4.
ASSEMBLY AND PREPARATION FOR USE (CONT)
18
Insert inboard end connector with O-rings on core tube of element.
19
Using clean rag and water, wash end cap assembly.
20
Lightly coat outside of end cap assembly O-ring with silicone lubricant (item 5, appendix D).
Aline end cap assembly with inboard end connector.
21
Rotate end cap assembly to aline with rigid tube. Gently push end cap assembly onto inboard
end connector in pressure tube.
22
Swing rigid tube back over end cap assembly. Install tube on end cap assembly. Tighten
tube nut.
23
Tighten rigid tube nut at manifold.
24
Install end clamp halves. Install two bolts and two nuts. Go to other (product water) end of
pressure tube.
2-91
