TM 10-4610-229-10
2-4.
ASSEMBLY AND PREPARATION FOR USE (CONT)
25
Lightly coat inboard end connector O-ring with silicone lubricant (item 5, appendix D). Insert O-
rings in groove of inboard end connector.
26
Insert inboard end connector with O-ring on core tube of element.
27
Using clean rag and water, wash end cap assembly.
28
Lightly coat outside of end cap assembly O-rings with silicone lubricant (item 5, appendix D).
Aline end cap assembly with inboard end connector.
29
Rotate end cap assembly to aline with rigid tube. Gently push end cap assembly onto inboard
end connector in pressure tube.
30
Swing rigid tube back over end cap assembly. Install tube on end cap assembly. Tighten rigid
tube nut and remove tag.
31
Tighten rigid tube nut at manifold.
32
Install flexible tube on end clamp assembly. Tighten flexible tube nut and remove tag.
33
Install end clamp halves. Install two bolts and two nuts.
34
Repeat steps 1 through 33 for other 15 pressure tubes.
2-92
