TM 10-4610-229-24
2-68. CARTRIDGE FILTER ASSEMBLY REPLACEMENT/REPAIR (CONT)
8
Install end plate on standoffs.
9
Install eight nuts and four retainer washers on four hold-down rods.
10
Insert hold-down rods in standoffs. Tighten lower nuts.
11
Install T-pipe assembly in end plate.
12
Lubricate gasket with grease. Install gasket on filter disc.
13
Install filter disc on end plate.
14
Insert reducer into filter disc and end plate, and over connecting pipe.
15
Using suitable lifting device and sling, install casing.
16
Turn retainer washing so that flat side faces away from casing.
17
Tighten upper nuts.
18
Place T-pipe in a vise.
19
Insert pipe in T-pipe.
20
Install pipe nipple and elbow.
21
Install two nuts, lanyard, and screw on dust cap.
22
Install pipe nipple and dust cap on elbow.
23
Install pipe nipple, bracket, conduit locknut, and elbow assembly on T-pipe.
24
Install lanyard, screw, flatwasher, and nut on bracket.
25
Remove T-pipe assembly from vise.
26
Install end plate and two capscrews on T-pipe assembly
27
Lubricate gasket with grease. Install gasket on filter disc.
28
Install filter disc on end plate.
29
Insert reducer in filter disc, end plate, and over pipe.
30
Install cage assembly (subpara d).
2-162
