TM 10-4610-229-24
CHAPTER 2
ORGANIZATIONAL MAINTENANCE
Section I. LUBRICATION INSTRUCTIONS
2-1.
GENERAL. For lubrication during maintenance, see the specific procedures contained in chapters 2 thru 4.
Scheduled lubrication intervals are found in table 2-1 and the lubrication order in LO 10-4610-229-10.
Section II. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-2.
COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to modified table of
organization and equipment (TOE) applicable to your unit.
2-3.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. Refer to TM 10-4610-22924P or the maintenance
allocation chart (MAC), appendix B.
2-4.
REPAIR PARTS. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (TM 10-4610-
229-24P) covering organizational, direct support, and general support maintenance for this equipment.
Section III. SERVICE UPON RECEIPT
2-5.
SERVICE UPON RECEIPT. For normal unpacking and deprocessing of the ROWPU, see TM 10-4610-229-10.
Perform quarterly (Q) Preventive Maintenance Checks and Services (PMCS).
Section IV. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-6.
GENERAL
a.
Always keep in mind the WARNINGS and CAUTIONS while performing PMCS.
b.
Report any deficiencies using the proper forms. See DA Pam 738-750.
c.
If the PMCS table requires removal of assemblies or equipment, refer to the maintenance procedures section of
this chapter.
2-7.
PURPOSE AND USE
a.
Purpose. The PMCS table lists the inspections and care of the equipment required to keep it in good operating
condition.
2-1
