TM 10-4610-229-24
2-69. GAGE PANEL ASSEMBLY REPLACEMENT/REPAIR (CONT)
CAUTION
Do not remove the three bracket screws. There are small springs around these screws which may
be lost.
2
Loosen three screws. Remove bracket.
3
Pull indicator from front of panel.
4
Install gage in panel from front.
5
Install bracket on back of gage. Tighten three screws.
6
Install pressure gage line.
f. Panel Replacement
1
Remove utility lamp (para 2-20).
2
Remove rheostat (subpara b).
3
Remove toggle switch (subpara c).
4
Remove two pressure differential switches (subpara d).
5
Remove three pressure indicator gages (subpara e).
6
Remove two nuts, flatwashers, and U-bolt from inlet pipe.
7
Remove two nuts, lockwashers, and bolts connecting panel and support frame.
2-169
