TM 10-4610-232-12
4-19.1. SEPARATOR PIPING. This task covers: (MODEL ROWPU-1 ONLY)
a.
Removal
b.
Repair
c.
Installation.
INITIAL SETUP.
Tools. see Appx B, Sec III, Ref Code (No.):
Equipment Condition:
Tool Kit, General Mechanics Automotive (1)
ROWPU shutdown.
Vise (2)
Wrench, Pipe (5) General Safety Instructions.
Materials/Parts
WARNING
Tape. Antiseize (Appx E, Sec II, Item 67)
Gaskets (TM 10-4610-232-24P)
Make certain in-line pressure is relieved from hoses.
Failure to do so could result in injury.
REMOVAL
Remove separator piping from the ROWPU unit by disconnecting all hoses attached to the separator piping and then
disconnecting coupling half (1) from coupling half (2).
DISASSEMBLY
a.
Remove two plugs (3), gasket (4), coupling half (5), reducer (6), check valve (7), and elbow (8) from coupling half
(1).
b.
Remove gasket (9) from coupling half (1).
Figure 4-21.1. Separator Piping.
(MODEL ROWPU-1 ONLY)
4-106.2 Change 7
