TM 10-4610-232-12
REASSEMBLY.
a.
Place cyclone separator (3) into position on strap (18) and install two brackets (17), four nuts (16), four flat
washers (15), and four screws (14).
b.
Install reducer (13), nipple (12), hose (11), and clamp (10) onto cyclone separator (3).
c.
Install elbow (9) and coupling half (8) onto cyclone separator (3).
d.
Install gasket (7) and coupling half cap (6) onto coupling half (8).
e.
Install elbow (2) and coupling half (1) onto cyclone separator (3).
f.
Install gasket (4) and coupling half (5) onto coupling half (1).
INSTALLATION.
Install separator onto ROWPU by replacing separator into stake pocket of trailer and then reconnecting all hoses to the
cyclone separator assembly.
Figure 4-22.1. Separators
(MODEL ROWPU-1 ONLY)
Change 7 4-109
