TM 10-4610-232-34
REASSEMBLY.
a.
b.
c.
d.
e.
Install feed port (6) through bearing plate (9) and secure with retainer rings (8).
Install preformed packings (7) into sealing plate (5).
Mount sealing plate (5) on short end of feed port (6).
Install preformed packing (4) in port permeator (3).
NOTE
Nut has left hand thread.
Install port permeator (3) through sealing plate (5), bearing plate (9) and secure with nut (2) by turning
Counterclockwise.
f. Install preformed packing (1) on sealing plate (5).
a. Position lower RO vessel brackets ( 15, Figure 2-62) on vertical bracket (14) and secure with eight capscrews (12),
sixteen (11), eight Iockwashers (10) and eight nuts (9).
b.
c.
d.
e.
f.
g.
h.
WARNING
To prevent injury, two personnel are required to install the RO vessels.
NOTE
There is a drain hole in the shell at each end of the RO vessel. The hole must be at the
6 oclock position (down) when installing.
NOTE
Install vessels furthest from center of trailer first.
Install the lower RO vassals one at a time.
WARNING
Van is on a 4 foot high trailer, Be careful not to fall off trailer when loading RO vessels.
Using lifting equipment install RO vessel through RO vessel access opening. Slide RO vessel (7) on rails (15).
Place saddles (8) on bracket, position vessel (7) in saddle.
Position protective gaskets (6) and holddown straps (5) on vessels.
Secure straps in place with four Iockwashers (2) and four nuts (1). (3) DELETED.
Torque J bolt nuts to 34 ft/lbs.
Repeat steps c through e for remaining lower level RO vessel.
i. Repeat step a for upper RO vessel brackets (13).
NOTE
Install upper vessel furthest from the center of the trailer first.
j. Repeat steps c through e for upper vessels.
Change 1 2-199
