DISASSEMBLY
REPAIR
REASSEMBLY
TM 10-4610-232-34
k. Loosen buckles (49) on outer canvas boot (50) and inner canvas boot (51).
k.1 Remove nut (52A), screw (52B), clamp (52C), and clamp (52C).
l. Remove high pressure hose (19) by pulling into container.
m. Remove low pressure hose (1) by pulling into container.
n. Remove air hose (35) by pulling into container and coiling up out of the way.
o. Remove three power cables (42, 43 and 44) by pulling into container and coiling up out of the way.
p. Push canvas boot (50, Figure 2-74, sheet 2) out of container wall before removing high pressure pump skid (64).
NOTE
Ratchet handle is stored on pump skid.
q. Press in on ratchet lever (53) and lift ratchet handle (54) fully to the rear to release tension on the hold down strap
(55).
r. Remove four clips (56) from trailer frame and slide out holddown straps (55).
s. Remove 24 capscrews (57), lockwashers (58) and washers (59), access cover (60) and lifting straps (61).
WARNING
Do not exceed load limits of lifting device. Do not operate lifting device without safety
latches in position on sling hooks. Failure to observe these precautions could result in
serious injury and damage to equipment.
t. Attach lifting sling hooks (61) to skid lifting ports (62).
CAUTION
When lifting high pressure pump skid, be careful not to damage air shock air hoses or
cover.
u. Use suitable lifting device to lift high pressure pump skid (64) from trailer and set off on flat terrain.
Unbuckle straps (65 and 66), internal straps and remove cover (67).
a. Inspect and repair any damaged components.
b. Replace straps (65 and 66) and zipper (68) in accordance with FM 43-3.
c. Sew rips and tears in cover (67) in accordance with FM 43-3.
Attach cover (67) to high pressure pump skid (64) with straps (65 and 66).
WARNING
Do not exceed load limits of lifting device. Do not operate lifting device without safety
latches on hooks. Failure to observe these precautions may result in serious injury
and damage to equipment.
Change 3
2-217
