TM 10-4610-239-24
TM 08580B-24/3
2-35. SNAP RINGS. Inspect snap rings for nicks, burns, distortion, loss of tension, and wear. Replace defective snap
rings.
2-36. SPRINGS. Inspect springs for wear, distortion, breaks, evidence of overheating, and loss of tension or
compression. Discard defective springs. Inspect springs using spring tester. Load and height inspection data, where
required, are contained in maintenance procedures.
2-37. SHAFTS AND SPINDLES.
A
Inspect shafts and spindles for excessive wear, binding, scores, cracks, burrs, and obstructed oil passages.
WARNING
Using compressed air can be dangerous. See general warning page.
b. Remove burrs and minor surface irregularities with crocus cloth or soft honing stone. Remove obstructions with
compressed air or by probing with soft wire. Replace parts with other defects.
2-63
