TM 10-4610-239-24
TM 08580B-24/3
(f)
Using needle nose pliers (4), grasp tang.
(g)
Turn insert (2) to the left until insert is out of tapped hole. Discard insert.
WARNING
Compressed air can blow dust into the eyes. Wear eye protection. Do not
exceed 30 psi (207 kPa) air pressure.
Drycleaning solvent AAF11 TYPE I & II is highly toxic and can ignite
organic materials, nitrates, carbides, and chlorates. Wear eye, skin, and
respiratory protection. Use in a well-ventilated area.
(h)
Lubricate finishing tap (5) with transmission oil.
(i)
Using finishing tap and tap handle, slowly thread tap in and out of tapped hole.
(j)
Using compressed air, blow dirt and any loose metal chips in tapped hole.
(k)
Use wiping rag dampened with cleaning solvent to clean tapped hole.
(l)
Loosen setscrew (6).
(m)
Turn handle until shaft (7) extends past tip of insertion tool (8) slightly longer than length of new insert
(9).
2-60
