TM 10-4610-239-24
TM 08580B-24/3
DISASSEMBLY.
a.
Remove street elbow (1).
NOTE
Cover is installed under tension. Relieve tension by loosening eyebolts a
few turns at a time in an alternating pattern.
b.
Loosen six eyebolt assemblies (2) and rotate them out of notches in cover (3). Remove cover
with attached parts.
c.
Position cover (3), handle down, on two stacks of 2 x 4' s.
NOTE
Retainer plate is attached to cover under tension. Hold retainer plate
down to make removal of nuts easier. Then slowly release tension.
Lift retainer plate straight up to prevent scattering top seat cups and springs.
d.
Remove three nuts (4) and retainer plate (5).
e.
Remove eight top seat cups (6) and springs (7).
f.
Install two nuts (4) on stud (8). Using wrench on inner nut, remove stud.
g.
Repeat for remaining studs. Remove six nuts from three studs.
h.
Remove and discard O-ring (9).
i.
Using drift pin, tap out six spiral pins (10) and remove six eyebolt assemblies (2).
j.
Remove and discard eight filter tubes (11).
k.
Remove four bolts (12) and shell (13).
CLEANING.
Using soft cloth and mild soap solution, wash all parts. Rinse thoroughly with clean water. Dry with clean, soft cloth.
2-173
