TM 10-4610-239-24
TM 08580B-24/3
ASSEMBLY.
a.
Position gasket (32) and connect tagged capacitor leads T9 and T10. Position capacitor cover(30) and install four
screws (29).
b.
Install pipe plug (17), T-drain (18), pipe plug (21), and T-drain (22) on end shields (11) and (19).
c.
Pack two bearings (24) and (26) with grease.
d.
Position retaining ring (27) on rotor (25) and, using arbor press, install centrifugal switch (28), bearings (24) and
(26) on rotor shaft (25).
e.
Position end shield (19) on rotor (25) and install two screws and washers (20) on retaining ring (27).
f.
Install wavy washers (23) in end shield (11).
g.
Position end shield (19) and rotor (25) in stator (12).
h.
Position stationary switch (16) on stator (12), connect two wire clips (15) and install screws (14).
i.
Hold end shield (11) close to stator (12), connect wires (13), align end shields (19) and (11) as previously marked
and install bolts (9).
j.
Position new gaskets (8), conduit spacer (7), new gasket (6) and onduit box (5) over wires of stator (12) and install
c
screws (4).
INSTALLATION.
a.
Position shaft key (7) and coupler (6) on motor (3) and tighten setscrew (5).
b.
Position motor (3) on drive housing (4).
c.
Install four screws (1) and lockwashers (2).
3-230
