TM 10-4610-240-10
TM 08580C-10/1
T.O. 40W4-13-21
NOTE
If low or high-pressure switches shut down the ROWPU automatically, they can only be reset with the
RESET switch. After emergency shutdown, distribution of potable water can still be made by pulling out
the EMERGENCY STOP button and running the distribution pump as required.
b. Start RAW WATER PUMP NO. 1.
(1) Go to control box assembly on the ROWPU. Locate the lamp and switch for RAW WATER PUMP No. 1.
(2)
Set switch upward to START.
(3) Hold switch up until lamp NO. 1 comes on.
(4) Release switch.
(5)
Switch will return to RUN.
(6) Look at output hose from raw water pump No. 1. Hose goes into suction side of raw water pump No.
2. Hose should expand and straighten out.
Figure 2-50. Switches (Pump Controls)
2-57
