TM 10-4610-241-24
TO 40W4-13-42
3-39. MOTOR (CHEMICAL FEED PUMP) REPAIR - continued .
(7)
Install two screws (14) and washers (15) to secure end plate (16) to end plate retainer (20).
(8)
Position capacitor cover gasket (12) on stator (24).
(9)
Feed wires, marked T9 and T1 0, trough small hole in side of stator and connect to capacitor as marked
during disassembly. If tags are lost or illegible, use information in illustration as a guide.
(10)
Position capacitor (13) on side of stator and secure to stator with cover (11) and four screws (10).
(11)
Position wavy washer (9) and load spring (8) on shaft of rotor (23).
(12)
Install gasket (6), stationary switch (5) and two screws (4) on end plate (7).
(13)
Connect motor wires to stationary switch as tagged. If tags are lost or illegible, connect wires, marked T9 and
T5 to stationary switch as indicated in illustration
(14)
Making sure that all loose wire ends extend thru large round hole in stator, position end cover (7) and attached
parts on stator (24).
(15)
Aline end plates (16 and 7) with scribe lines, marked at disassembly, on stator and install four washers (3),
lockwashers (2) and thru bolts (1).
3-221
