ARMY TM 10-4610-309-14
MARINE CORPS TM 10802A-14/1
0005 00
TACTICAL WATER PURIFICATION SYSTEM (TWPS)
PREPARATION FOR USE AND INSTALLATION INSTRUCTIONS
EQUIPMENT OFF-LOADING ARMY UNIT
A-TWPS REMOVAL FROM PLS TRAILER
If the A-TWPS was transported on a PLS Trailer, rollers were installed on the flat rack in order to roll the
A-TWPS onto the trailer from the PLS Truck. After the PLS Truck is unloaded, the A-TWPS is rolled off
the trailer and onto the truck using the arm on the PLS Truck. Before the A-TWPS is set on the ground
from the PLS Truck, the rollers must be removed from their in-use brackets and installed in their storage
brackets as follows:
1. Remove both rollers from their in-use brackets at the operator station end of the flat rack as
follows (see Figure 1):
a. Remove the retaining pins.
b. Pull out the roller axle.
c. Lift the roller out of the in-use bracket.
2. Install both rollers in their storage brackets at the bail bar end of the flat rack as follows (see
Figure 1):
a. Position the roller in the storage bracket.
b. Slide the roller axle through the bracket and roller.
c. Insert a retaining pin in both ends of the axle.
IN-USE
BRACKET
RETAINING PIN
AXLE
ROLLER
STORAGE
BRACKET
Figure 1. Flat Rack Roller Storage.
0005 00-2
