TM 10-4610-310-14
0112 00
TERMINAL BLOCK (WHITE, GREEN, BLACK)
Removal
1. Determine appropriate terminal block. Wiring matches the color of the terminal block.
2. Disconnect two wires (black, white, green/yellow) from terminals on terminal block.
3. Use a flat tip screwdriver and place in slot at bottom of terminal block.
4. Pry terminal block from mounting channel.
5. Discard terminal block.
Installation
1. Position terminal block into appropriate slot on mounting channel (23). See Figure 4.
2. Snap terminal block into position.
3. Connect two black, white, or green wires to appropriate terminals on terminal block. See Figure 3.
INCANDESCENT LAMP
Removal
1. Remove two screws from selector switch handle. See Figure 2.
2. Remove handle from switch base.
3. Push and twist incandescent lamp to remove. Use the 3/8" diameter rubber hose in tool kit.
4. Discard lamp.
Installation
1. Insert new incandescent lamp into position. Use the 3/8" diameter rubber hose in tool kit.
2. Push and twist lamp to lock into position.
3. Place handle over selector switch base. See Figure 2.
4. Install two screws into switch handle. Tighten securely.
ELECTRICAL CORD
Removal
1. Remove electrical cord from spool. See Figure 1.
2. Loosen cord connector and aluminum hub from enclosure.
3. Turn access lock counter clockwise to open panel cover.
4. Remove three wires (black, white, green) from color coded terminal blocks. See Figure 3.
5. Remove cord connector, aluminum hub, and electrical cord from enclosure.
6. Inspect cable plug (P1) for burns, damage, pins bent or missing. Replace as necessary.
Installation
1. Place cord connector and aluminum hub on new electrical cord.
2. Insert cord through cutout in top of enclosure.
3. Connect three wires (black, white, green) to appropriate color coded terminal blocks. See Figure 3.
4. Tighten aluminum hub and cord connector with electrical cord.
5. Close panel cover and turn access lock clockwise to secure.
END OF WORK PACKAGE
0112 00-5 / 6 blank
