TM 5-3800-205-10-2
EXTERNAL AIR TRANSPORT BY CH-47 HELICOPTER - CONTINUED
0016 00
MACHINE ASSEMBLY - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Tools and equipment required for machine assembly are located in BII toolbox on rear deck of water
distributor.
If ISU-60 container has not been delivered to site of machine assembly, performance of selected steps
will need to be delayed until container arrives. Proceed with assembly of machine, returning to these
steps as soon as container is available.
7.
Place ISU-60 container near machine assembly area and remove the following items from container, in accordance with
illustrations and information in Tables 5 and 6:
a.
fenders;
b.
torque wrench;
c.
toolbox (minus tools and equipment placed in BII toolbox on water distributor);
d.
ROPS/FOPS;
e.
windshield (with hinge);
f.
upper handrail (with side mirror);
g.
exhaust stack;
h.
windshield wiper arm assembly;
i.
engine grille; and
j.
three guard plates.
0016 00-40
