TM 5-3800-205-10-2
EXTERNAL AIR TRANSPORT BY CH-47 HELICOPTER - CONTINUED
0016 00
MACHINE ASSEMBLY - CONTINUED
Table 5. Unpacking ISU-60 Container - Two-Door End.
COMPONENT
UNPACKING INSTRUCTIONS
NOTE
Container center post must be removed to allow unpacking of fend-
ers. Remove retainer and post.
Fenders
1.
Release straps from both fenders.
2.
Remove fenders from container.
Torque Wrench
1.
Release three straps.
2.
Remove torque wrench from cushion pad at back of shelf.
Table 6. Unpacking ISU-60 Container - Single-Door End.
COMPONENT
UNPACKING INSTRUCTIONS
Ramps
1.
Remove two roller ramps from right-side wall of container.
2.
Install each ramp at door opening, with two pins through each ramp into holes in
edge of floor.
Toolbox
1.
Remove two pins and slide out tray.
2.
Release three straps and remove toolbox from tray.
ROPS/FOPS
1.
Release two straps from ROPS/FOPS.
WARNING
ROPS/FOPS weighs 447 lb (203 kg). Use extreme caution when lifting and do
NOT allow to swing free. Failure to do so may result in injury or death to per-
sonnel.
CAUTION
Use caution not to damage windshield when handling ROPS/FOPS.
2.
Use a suitable three-point lifting device to lift ROPS/FOPS clear of tray.
CAUTION
Windshield (with
Hinge)
Use caution not to damage windshield during handling. Do not
remove from container until ready to install.
1.
Release one strap from windshield.
2.
Carefully remove windshield (with hinge) from cushion pad.
NOTE
To remove all remaining components, remove straps as required and
lift out component.
0016 00-42
