TM 5-3800-205-10-2
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIRDROP
NOTE
To facilitate machine disassembly and sectionalization, it is crucial that machine be positioned on level
ground, with tractor and water distributor aligned and steering centered.
If possible, position machine in direction of helicopter's takeoff, so that pilot does not have to pick up
load, then turn aircraft into takeoff direction.
When hydraulic hose guide disconnects need to be disconnected, operate control levers through all posi-
tions (WP 0004 00) to relieve any trapped hydraulic pressure in hoses. This will facilitate disconnection
of hoses.
1.
Position machine on level ground. Ensure tractor and water distributor are aligned and steering wheel is centered. Place
transmission in N (Neutral) and lock, apply parking brake, and lower tank to the ground. Shut down engine. Block trac-
tor and water distributor wheels.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
2.
Place ISU-60 container near work area and remove the following items from container:
a.
toolbox;
b.
exhaust extension; and
c.
four steering locking collar assemblies, two short (6 5/8 in.) and two long (10 3/4 in.).
STEERING CYLINDER
LOCKING COLLAR ASSEMBLIES
EXTENSION
390-1119
TOOLBOX
0018 00-3
