TM 5-3800-205-10-2
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIRDROP - CONTINUED
20.
Stow the following tools, required for machine assembly after airdrop, in BII toolbox on rear deck of water distributor:
a.
bar, breaker, 1/2 in. drive;
b.
extension, socket, 1/2 in. drive, 5 in. long;
c.
socket, 1/2 in. drive, 9/16 in.;
d.
tool, tire repair;
e.
wrench, combination, 7/16 in. (2);
f.
wrench, combination, 1/2 in.; and
g.
wrench, combination, 9/16 in.
21.
Ensure all compartment doors and BII toolbox on rear deck of water distributor are closed, latched, and secured with
padlocks.
22.
Position machine on airdrop platform that has been suitably prepared.
23.
Block and shore machine securely and tie down on platform in accordance with shipping data plate on machine, FM 10-
576 (Airdrop of Supplies and Equipment), and Air Force regulations.
24.
Check security of machine on airdrop platform. Ensure all blocking and shoring is properly installed and secured to plat-
form with nails.
25.
Rig machine for airdrop by parachute, in accordance with shipping data plate on machine. Suspension provisions are
stenciled "ATTACH DROP PARACHUTE HERE".
26.
Load platform into C-130 aircraft.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure any lifting device used is in good condition and of suitable lift capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in death or injury to person-
nel.
NOTE
It is important to stow components in container in accordance with indicated sequence. This will ensure effi-
cient and timely packing of container.
27.
Stow the following items in ISU-60 container in accordance with illustrations and information in Table 1.
a.
exhaust stack;
b.
windshield wiper arm assembly;
c.
upper handrail (with side mirror);
d.
ROPS/FOPS; and
e.
toolbox (minus tools placed in BII toolbox on water distributor).
0018 00-17
