TM 5-3800-205-10-2
AIRDROP BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIRDROP - CONTINUED
WINDSHIELD WIPER ARM ASSEMBLY
EXHAUST
STACK
UPPER
HANDRAIL
(WITH SIDE
MIRROR)
RAMPS
TRAY
RETAINING
PIN
390-1135
TOOLBOX
ROPS/FOPS
WINDSHIELD
(WITH HINGE)
Table 1. Stowage Instructions for ISU-60 Container - Single-Door End.
COMPONENT
STOWAGE INSTRUCTIONS
1.
Place exhaust stack in left cutout of cushion pad, on left side of shelf. Lower end
Exhaust Stack and
of stack should be facing out.
Windshield Wiper Arm
2.
Place windshield wiper arm assembly next to exhaust stack.
Assembly
3.
Secure components with three straps.
Upper Handrail (with
1.
Place against right-side wall of container.
Side Mirror)
2.
Secure with one strap.
ROPS/FOPS
WARNING
ROPS/FOPS weighs 447 lb (203 kg). Use extreme caution when lifting and do
NOT allow to swing free. Failure to do so may result in injury or death to per-
sonnel.
CAUTION
Use caution not to damage windshield when handling ROPS/FOPS.
1.
Using a suitable three-point lifting device, lift ROPS/FOPS into position over tray,
with front of ROPS/FOPS to the right.
2.
Lower ROPS/FOPS onto four studs, one at each corner of tray.
3.
Secure ROPS/FOPS with two straps.
0018 00-18
