TM 5-3800-205-23-3
FUEL PUMP, HOSES, AND TUBES REPLACEMENT - CONTINUED
0001 00
FUEL PUMP INSTALLATION
NOTE
Lubricate new O-rings with clean fuel.
1.
Install new O-rings and fittings to fuel pump (3).
2.
Install two wires (2) to fuel pump (3) with two new lockwashers (6) and nuts (5). Apply varnish over electrical connec-
tors.
NOTE
To ensure proper operation, arrow marking on fuel pump must point toward front of water tank.
3.
Install fuel pump (3) to rear of water tank with clamp (9), new lockwasher (8), and nut (7).
CAUTION
Use two wrench method when connecting fuel hoses to avoid damage to ceramic adapter.
4.
Connect hoses (1 and 4) to fuel pump (3).
5.
Open fuel shutoff valves (TM 5-3800-205-10-2).
6.
Place battery disconnect switch in ON position (TM 5-3800-205-10-2).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
7.
Start engine (TM 5-3800-205-10-2) and check for leaks.
8.
Install rear steps (WP 0018 00).
FUEL HOSES REMOVAL
NOTE
Perform following steps to remove each of seven fuel hoses of water distributor. Hoses are connected to
fuel pump, fuel/water separator, fuel tubes, valves, and fittings. Fittings include elbows, tees, and adapt-
ers.
Fuel pump hose is illustrated.
0001 00-3
