TM 5-3800-205-23-3
FUEL PUMP, HOSES, AND TUBES REPLACEMENT - CONTINUED
0001 00
FUEL HOSES INSTALLATION
NOTE
Perform following steps to install each of seven fuel hoses of water distributor. Hoses are connected to
fuel pump, fuel/water separator, fuel tubes, valves, and fittings. Fittings include elbows, tees, and adapt-
ers.
Fuel pump hose is illustrated.
Lubricate new O-rings with clean fuel.
1.
Connect hose (1) and new O-ring (11) to fuel/water separator (12).
2.
Connect other end of hose (1) and new O-ring (10) to fuel pump (3).
3
1,10 (HIDDEN)
11 (HIDDEN)
12
390-1551
3.
Open fuel shutoff valves (TM 5-3800-205-10-2).
4.
Place battery disconnect switch in ON position (TM 5-3800-205-10-2).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
5.
Start engine (TM 5-3800-205-10-2) and check for leaks.
6.
Install rear steps (WP 0018 00), if removed.
0001 00-5
