TM 5-4610-223-12
Legend for figure 3-8:
1.
Cable assembly (3 ea)
21.
Bushing (2 ea)
2.
Cable assembly (2 ea)
22.
Wrench, adJustable
3.
Paddle
23.
Wrench, open end 7/16-1/2
4.
Blind flange (6 ea)
Wrench, open end 9/16-5/8
5.
Float
Wrench, open end 11/16-13/16
6.
Hose clamp (12 ea)
Wrench, open end 7/8-15/16
7.
Capscrew (12 ea)
24.
Wrench, pipe (2 ea)
8.
Pipe cap (6 ea)
25.
Wrench spanner (2 ea)
9.
Ground rod
26.
Valve, gate 2 in.
10.
Publication case
27.
Hand hammer
11.
Knife pocket
28.
Hose (6 ea)
12.
Light extension
29.
Hose (8 ea)
13.
Light extension
30.
Hose suction (6 ea)
14.
Scoop kitchen
31.
Key set, socket head screw
15.
Screwdriver flattip
32.
Lubrication gun
16.
Screwdriver crosstip
33.
Nozzle fuel (2 ea)
17.
Siamese connection
34.
Pliers, slip joint
18.
Strainer, suction hose
35.
Measure, dry chemical aluminum
19.
Adapter, straight, pipe
35.
Measure, dry chemical plastic
to hose (3 ea)
36.
Pail, utility
20. Adapter (5 ea)
37.
Measure
3-21. ERDLATOR AGITATOR DRIVE MOTOR.
a.
General. The motor (fig. 3-9) is located on the bridge rails on top of the erdlator tank. It provides power to the
erdlator agitator by means of a pulley, belt, shaft and speed reducer. It is a three-phase, totally enclosed motor with
oblong mounting holes in the base for adjustment and alignment.
WARNING
Drycleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property.
Wear chemical resistant gloves when using solvents, and avoid repeated or prolonged skin contact.
Do not use near open flame or excessive heat. Flash point of solvent is 100 degrees F to 138
degrees F (38 degrees C to 59 degrees C).
b.
Cleaning. Clean the drive motor with a cloth dampened with drycleaning solvent.
c.
Inspection. Inspect the motor for signs of overheating, worn bearings, and damaged wires and insulation.
Inspect the drivebelt for damage.
3-36
