TM 55-1930-209-14&P-11
3-6.1 Accessing edit mode
a.
Press EDIT keyboard key (Figure 3-3). Make sure key lights and following edit menu appears on video
monitor
MENU
TO SELECT OPTION, PRESS KEY BELOW NUMBER
1 - PRINT LAST PAGE
2 - PRINT ALL PAGES
3 - PRINT ALARMS
4 - SYSTEMS STATUS PAGE
5 - SYSTEM EDIT
6 - KEYBOARD LAMP TEST
NOTE
The above menu, in these instructions, is called the "basic menu" to separate It from an "edit
menu" and from "prompts."
b.
Ignore options 1, 2 and 3 They do not apply to ROWPU barge application.
c.
If temperature reading inside main processor is desired, push keyboard key 4 (GEN ALARMS) now functioning
as a number 4 This selects option 4-SYSTEMS STATUS PAGE, which in ROWPU barge application of the EMS,
selects procedures for obtaining internal EMS temperature. Follow procedures In paragraph 3-3h
d.
To perform keyboard lamp test, push keyboard key 6 (BILGE ALARMS) now functioning as a number 6. This
selects option 6 KEYBOARD LAMP TEST Follow procedures In paragraph 3-3g.
e.
Push keyboard key 5 (H P WTR PUMP ALARMS) now functioning as number 5. This selects option 5-SYSTEM
EDIT Make sure following Is displayed on video monitor.
ENTER EDIT ACCESS COMBINATION
NOTE
This combination prevents unauthorized entry Into EMS programs. Two levels of editing are
available, level 1 and level 2. The bargemaster has access combination for each.
f.
Contact bargemaster to obtain access combination or combinations for use. Proceed to paragraph 3-.2 if level 1
edit access is desired or paragraph 3-.3 if level 2 edit access is desired.
3-6.2 Level 1 editing. Select level 1 editing by entering access combination for level 1 edit. Following display appears:
EDIT MENU
TO SELECT OPTION, PRESS KEY BELOW NUMBER
1 - ACTIVATE/DEACTIVATE SENSORS
2 - ACTIVATE/DEACTIVATE SWITCHES
3 - ACTIVATE/DEACTIVATE/PRESET TOTALIZERS
4 - SET TIME/DATE
5 - EDIT SCHEDULE LOG
3-14
