TM 55-1930-209-14&P-11
e.
Push ENTER keyboard key. Make sure prompt information changes to the following:
1 - ADVANCE CURSOR
2 - EDIT THIS ONE
3 - SELECT NEW BAR
f.
Repeat steps a through e for changing reference marks of additional sensors.
g.
When desired reference marks are changed, press EXIT keyboard key to return video monitor to normal
scanning and to leave Edit mode, or press '3" keyboard key (SELECT NEW BAR) to return to display page.
h.
When display page appears on video monitor screen, take one of these actions:
(1)
Push keyboard key 1 (prompt ADVANCE CURSOR) to move cursor to select a new sensor.
(2)
Push keyboard key 3 (prompt SELECT NEW PAGE) to select a new page
(3)
Push keyboard key 4 (prompt RETURN TO EDIT MENU) to return to EDIT MENU.
3-6.2.3 Using EDIT MENU option 2 to activate/deactivate switches
NOTE
Switches are activated/deactivated for the same reason and in a similar manner to
activating/deactivating sensors in paragraph 3-6.2.1.
Deactivating a switch stops main processor from monitoring that particular switch.
Deactivation may be necessary when a switch Is malfunctioning, is displaying false
information on video monitor display page and Is activating alarms when no problem exists.
When a switch is deactivated, the word DEACTIVATED appears in place of the switch emblem
on video monitor display page. After switch is repaired or replaced, switch Is reactivated.
The word DEACTIVATED disappears and switch emblem again appears on video monitor.
a.
Push keyboard key 2 (EDIT MENU option ACTIVATE/DEACTIVATE SWITCHES). Make sure page select
prompt In step 3-6.2 la appears on video monitor
b.
Push keyboard key that shows switch data, such as GENERATORS display page (Figure 3-) or HIGH
PRESSURE WATER PUMPS (Figure 3-9) display page.
(1)
Make sure display page chosen shows on video monitor.
(2)
If highlighted Instructions called "prompts," shown below, are displayed on screen and switch closest to top
left side of the page is double intensity, go to step c.
1 - ADVANCE CURSOR
2 - EDIT THIS ONE
3 - SELECT NEW PAGE
4 - RETURN TO EDIT MENU
(3)
If screen flashes, indicating display page has no switches, either press another display page key or press
EDIT key to return to EDIT MENU.
c.
Push
keyboard
key
1
(prompt
ADVANCE
CURSOR)
and
move
cursor
to
switch
to
be
activated/deactivated./deactivated
3-17
