TM 55-1930-209-14&P-11
NOTE
Cursor will be on "O" MONTH
b.
Push keyboard key 1 (prompt ADVANCE CURSOR) to move cursor to item (MONTH, DAY, YEAR, etc.) to be
changed.
c.
Push keyboard key 2 (prompt EDIT THIS ONE). Make sure cursor extends through old value.
NOTE
By pushing keyboard number keys (as well as "-" and "."), keys act as calculator keys and
write numbers on video monitor.
d.
Use keyboard keys to enter new values.
e.
Push ENTER keyboard key. Note that cursor will shorten.
NOTE
If video monitor shows message "MIN" or "MAX," allowable range has been exceeded.
f.
If allowable range has been exceeded, repeat steps c and d, otherwise go to step g.
g.
Repeat steps b through f until correct date and time is entered in NEW column.
NOTE
With time and date set, with seconds set to zero, clock starts when EXIT keyboard key is
pushed to move video monitor to normal scanning of display pages.
h.
Press EXIT keyboard key to leave edit mode and return EMS video monitor to normal scanning or push keyboard
key 3 (prompt RETURN TO EDIT MENU).
3-6.3 Level 2 editing procedures. Select level 2 editing by entering access combination for level 2 edit obtained from
bargemaster to change display page information Make sure following EDIT MENU display appears
EDIT MENU
TO SELECT OPTION, PRESS KEY BELOW NUMBER
1. EDIT BATR PARAMETERS
2. EDIT SWITCH PARAMETERS
3. EDIT TOTALIZERS
4. EDIT ALARM INHIBITS
5. SET TIME/DATE
6. EDIT SCHEDULE LOG
NOTES
High and low alarm points are typical data that can be set in level 2.
Video monitor displays many Items that pertain to general monitoring system capability and
are not part of EMS as used onboard ROWPU barges. Items that are used onboard have data
printed under OLD column; those that do not often have "N/A" (not applicable) in that column.
3-20
