TM 55-1930-209-14&P-19 Table 6-2.  Preventive Maintenance Checks and Services for Shore Discharge System (Continued) B - Before D - Daily Q -  Quarterly D - During W - Weekly S -  Semiannually A - After M - Monthly A -  Annually INTERVAL ITEM PROCEDURES EQUIPMENT ITEM TO BE CHECK FOR AND HAVE IS NOT READY/ NO. INSPECTED REPAIRED OR ADJUSTED AVAILABLE IF B   D   A   D  W  M   Q   S   A AS NECESSARY 9 Discharge Hose Outer Jacket NOTE Minor damage to the discharge hose outer jacket, such as surface tears, cuts, and scratches need not be repaired.  If the entire outer jacket layer Is damaged to the next layer, repair the damage as follows, using outer jacket repair kit Check that hose is secure and outer Hole is visible in jacket is not damaged.  Repair as neces- hose. sary as follows: 1)   Set hot air gun on 3. 2)   Hold gun about 1 in.  from area to be repaired to melt material around the damage. NOTE Use original outer jacket material.  Add new material only if necessary.  During repair use stainless steel bands if needed to hold outer jacket In place. 3)   When outer jacket material melts, use putty knife to press softened material into damaged area until repair is com- pleted as shown in Figure 3-13. 4)   if necessary, use stainless steel bands to hold the repaired area. 10 Hand (Band) a. Check brake for excessive wear and that Excessively Brake hand brake holds when set Notify shift worn. leader or bargemaster of deficiencies. b. Make sure hand brake on starboard side of winch is set.  f not, set as follows: 1)   Open valve SD3. 2)   Obtain hand brake pump handle from stowed position and insert in pump extension. CAUTION While pumping, do not exceed 4,000 psi as indicated on hand brake pressure gauge. 6-7