Engine
Disassembly and Assembly
Assemble Governor 1264-016
Tools Needed
A
B
C
D
6V2054 Shield Driver*
1
1P1855 Retaining Ring Pliers
1
6V2163 Compressor Clamp
1
1P510
Driver Group
1
*Part of 6V4095 Pump And Governor Reconditioning
Tool Group
NOTE: If the governor was removed only for repair of the
fuel injection pump housing, do only Steps 1, 4, 5, 7, 9,
10, 11, 16, 22, 38, 39 and 40.
NOTE: Put clean engine oil on all parts before assembly.
Be sure all oil passages are clean.
1.
Install one race (1), bearing (2) and the other
race (1) on the camshaft in the fuel injection pump
housing as shown.
2.
Put flyweights (3) in position on carrier (4), and
install the dowels to hold the flyweights in place. The
flyweights must move freely on the dowels and have
0.010 to 0.23 mm (0.0004 to-0.009 in.) end play.
3.
Install dowel (5) in governor shaft (6), and install
the governor shaft in the carrier as shown.
4.
Put the carrier in position on the camshaft, and
install the bolts that hold the carrier in place.
23