Engine
Disassembly and Assembly
Governor
22.
Remove lockring (46), seat (45), spring (broken
link spring) (44) and sleeve (43) from valve (42).
Remove the other lockring (46) from the groove in the
center of valve (42).
NOTE: The groove in the bottom of valve (42) must be in
alignment with the servo body to permit removal from the
fuel rack.
23.
Remove valve (42), sleeve (47) and piston (49)
from the governor servo. Remove the O-ring seal from
sleeve (47).
24.
Remove pin (48) and lever (50) from the
governor servo.
25.
Use
tool
(C)
to
hold
spring
(52)
under
compression so ring (51) can be removed. Spring (52) is
used to put a preload on the thrust bearing for the
camshaft in the fuel injection pump housing.
26.
Remove ring (51); then remove tool (C).
27.
Remove bearing (53), sleeves (54) and spring
(52) from the governor shaft.
28.
Remove ring (55) and dashpot assembly (56)
from the governor shaft.
20
