Engine
Disassembly and Assembly
Governor
NOTICE
Replace shield (7) with a new part any time it is removed.
5.
Install shield (7) on the carrier, and use tool (A)
to push the shield against its seat. Use a hammer and
punch to stake the metal in two places on the side of the
shield 180 5 apart next to the holes in the shield.
6.
Install one race (9), bearing (10), the other race
(9), and use tool (B) to install the ring on riser (8) as
shown.
7.
Install riser (8) and the spring (overfueling
spring) on the governor shaft as shown.
8.
Assemble the dashpot as follows:
a.
Install spring (12) on seat (11) and install seat
(13) in spring (12).
b.
Put spool (14) and ring (15) in position on seat
(13), and use tool (B) to install snap ring (16) to hold
them in place.
9.
Install dashpot assembly (17) on the governor
shaft as shown.
24
