Engine
Disassembly and Assembly
Rocker Shaft Assembly
4. Install pin (3) through the bracket and shaft with a
hammer.
5. Pin (3) must extend 9.60 mm (.378 in.) above the
bracket.
6. Install O-ring seal (7) in the rear support bracket.
Install rocker arm (8), the original number of washers,
spring, washer and the retainer ring on the rocker shaft.
7. Install the front support, rocker arm, original number
of washers, spring, washer and the retainer ring on the
rocker shaft.
8. Install the plugs in each end of the rocker shaft if they
were removed.
END BY:
a. Install
rocker
shaft
assembly
and
push
rods
Cylinder Head Assembly And
Spacer Plate
Remove Cylinder Head Assembly And
Spacer Plate 1100 & 1221-011
Tools Needed
A
5P9736
Link Bracket
2
START BY:
a.
remove rocker shaft assembly and push rods
b.
remove exhaust manifold
c.
remove air cleaner group
d.
remove aftercooler
NOTE: The procedure which follows was done on a 3306
Engine.
1.
Remove bolts (1), mounting bracket and pipe
assembly (2) and lifting bracket (3) from the cylinder
head assembly.
78
