Engine Disassembly and Assembly
2.
Remove temperature sending unit (5) from elbow
(4).
3.
Loosen clamp (6), and remove the bolts that hold
elbow (4) to the water pump and cylinder head assembly
Remove the elbow and gaskets from the engine
4.
Install tooling (A) on the cylinder head assembly as
shown, and fasten a hoist on It
NOTICE
Do not set the cylinder head assembly on a flat
surface because of possible damage to the fuel
injection nozzle tips.
5.
Remove all bolts (7) and (8) that hold the cylinder
head assembly to the cylinder block. Remove the
cylinder head assembly. The weight of the cylinder
head assembly (3304) is 64 kg (142 lb. ). The weight of
the cylinder head assembly (3306) is 95 kg (210 lb. ).
6.
Remove head gasket (9), water seals (11) and the
O-ring seal from dowel (10). Remove spacer plate (12),
the spacer plate gasket and the O-ring seal from dowel
(10).
79
