Engine
Disassembly and Assembly
c.
Put 9S3265 Retaining Compound on the outside
diameter of crankshaft (3) and the inside diameter of
wear sleeve (2).
NOTE: Make sure the lip of the seal is toward the engine
and the outside diameter bevel of the wear sleeve is
toward the outside of the engine.
d.
Put wear sleeve (2) with seal (1) on the front of the
crankshaft as shown in illustration B20159X1. Install
tooling (A). Tighten the bolt in tooling (A) until the inside
surface of the installer in tooling (A) makes contact with
the end of the crankshaft.
END BY:
a.
install crankshaft vibration damper and pulley (3306)
b.
install crankshaft pulley (3304)
Crankshaft Pulley (3304)
Remove Crankshaft Pulley (3304)
1205011
Tool Needed
A
FT915
Plate
1
S1590
Bolt [3/8"-16 NC x 2 in. (51 mm)
6
long]
SF7342
Adapter
2
8B7550
Leg
2
8B7560
Step Plate
1
8B7548
Push-Puller
1
8H684
Ratchet Wrench
1
NOTICE
If the spacer is not used, damage to the bolt thread
can be the result.
1.
Remove hub retaining bolt (1) and washer (3) from
the end of the crankshaft. Install a spacer (2), washer
(3) and bolt (1) on the crankshaft. The spacer is
installed behind the washer to get approximately 3.18
mm (.125 in.) of clearance between washer (3) and
pulley (4).
101
