Engine
Disassembly and Assembly
NOTICE
If spacers (4) are not used, damage to the bolt and/or
crankshaft can result when the vibration damper and
pulley are removed from the crankshaft.
2.
Install tooling (A) as shown, and loosen vibration
damper and pulley assembly (3) from the crankshaft.
3.
Remove tooling (A), bolt (1), washer (2), washer (4)
and the vibration damper and pulley assembly from the
crankshaft. If necessary, remove the bolts and vibration
damper from the pulley.
NOTE: Inspect the vibration damper housing for leakage
or dents (damage housing). If either condition exists, a
replacement of the vibration damper must be made.
Install Crankshaft Vibration Damper
And Pulley (3306)
1205-012
1.
Put the vibration damper In position on the pulley,
and install the bolts that hold it.
2.
Put vibration damper and pulley assembly (1) in
position on the crankshaft, and install washer (2) with the
maximum flat area against the vibration damper and
pulley assembly.
3.
Install bolt (3), and tighten it to a torque of 284 to 340
Nm (210 to 250 Ib.ft.). Hit the bolt with a hammer, and
tighten the bolt again to a torque of 284 to 340 Nm (210
to 250 Ib.ft ).
103
