Engine
Disassembly and Assembly
Front Support
Remove And Install Front Support
1153-010
NOTE: The engine shown is mounted on an OTC Model
1750A Engine Repair Stand. If the engine is not on a
repair stand, it will be necessary to remove the bolts from
locations (A); then block the engine in a position so front
support (1) is off the mounting brackets.
1.
If the engine is equipped with alternator, remove the
alternator. See Remove Alternator.
2.
Remove all bolts (2) that hold the front support to the
engine. Remove the front support.
3.
Put front support (1) in position on the engine. and
install all bolts (2) that hold it.
4.
If the engine is equipped with an alternator, install
the alternator. See Install Alternator.
Gauge Group
Remove Gauge Group 7450-011
1.
Disconnect water temperature sending unit (1) from
the water pump elbow.
2.
Remove bolt (2), the nut and clip (3) that hold the oil
line.
3.
Disconnect oil line (4) from the engine.
104
