Engine
Disassembly and Assembly
Oil Pump (3304)
Install Oil Pump (3304) 1304-012
1.
Turn the crankshaft until the No. 1 piston is at top
center of the compression stroke. See Testing And
Adjusting for this procedure.
2.
Turn both balance shafts (1) until the flat part of the
shaft is away from the oil pan plate.
Install bolts (3) [3/8"-16 NC x 51 mm (2 in.) long through
the holes in the oil pan plate and into the threaded holes
in the balancer shafts.
3.
Install idler gear (2) on the oil pump. Put oil pump (5)
in position on the engine as shown. Make sure the oil
pump gears are engaged with the balancer shaft gears
and the crankshaft gear. Install the bolts, washer and
locks that hold the oil pump in position.
4.
Install bolts (4) that hold the elbow to the oil pump.
5.
Remove bolts (3) from the balancer shafts. Remove
the timing bolt from the flywheel.
END BY: a. install oil pan
Oil Pump (3306)
Remove And Install Oil Pump (3306) 1304-010
START BY:
a.
remove oil pan
1.
Remove the bolt and lock that holds suction bell (1)
to the oil pan plate. Remove two bolts (4) that hold the
elbow to the oil pump.
Oil pump idler gear (2) can fall off the pump when
the pump is removed. To prevent injury, always hold
the gear on the pump when the pump is removed.
2.
Remove the bolts and locks that hold the oil pump to
the engine. Remove oil pump (3).
3.
Install idler gear (2) on oil pump (3). Put the oil pump
in position on the engine as shown with idler gear (2)
engaged with the crankshaft gear. Install the bolts and
locks that hold the oil pump to the engine.
134
