TM 10-4610-229-24
2-71. CONTROL PANEL ASSEMBLY REPLACEMENT/REPAIR (CONT)
k. Electrical Enclosure Replacement
1
Remove two pump switches (subpara c).
2
Remove two indicator lights (subpara d).
3
Remove backwash timer (subpara e).
4
Remove inverter (subpara f).
5
Remove fuse block (subpara g).
6
Remove terminal block (subpara h).
7
Remove POWER ON OFF switch (subpara i).
8
Remove pilot light (subpara j).
9
Remove cords, cables, conduit, and wires (subpara a).
10
Remove knockout plug from bottom of enclosure.
11
Remove four nuts and washers from top and bottom of inverter mounting brackets. Remove brackets.
12
Remove four nuts, lockwashers, and bolts. Remove enclosure.
13
Install enclosure. Install four bolts, lockwashers, and nuts.
14
Install inverter mounting brackets. Install four washers and nuts at top and bottom of brackets.
15
Install knockout plug in bottom of enclosure.
2-186