TM 10-4610-229-243-8. FUEL INJECTION PUMP REPLACEMENT/REPAIR (CONT)4Remove three injection pump mounting screws with washers.5Remove injection pump and shims.b.InstallationNOTEShims are needed under injection pump for correct start of delivery. Shims installed should be ofthe same thickness as those removed.1Install shims and injection pump. Install three screws and washers.2Install seal on banjo bolt. Insert banjo bolt through fitting on fuel return line end. Install second seal.3Install fuel return line with banjo bolt. Do not tighten banjo bolt.4Turn decompression lever half way between 0 and 1.5Crank engine until fuel comes from banjo bolt and injection pump line without air bubbles. Tighten hollowscrew.6Check start of delivery (subpara d).7Install fuel delivery line. Install nuts.8Install air filter bottom. Tighten clamp.3-17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business