TM 10-4610-229-24
3-7. STARTER ASSEMBLY REPAIR (CONT)
8
Remove armature assembly from starter housing.
9
Remove field coil from armature.
10
Remove bushing, flatwasher, splitwasher, and bushing from armature assembly.
11
Remove armature from drive bendix.
12
Remove cotter key and pin. Remove fork lever from starter housing.
b.
Assembly
1
Install fork lever in housing.
2
Install pin and cotter key.
3
Install armature in drive bendix.
4
Install bushing, splitwasher, flatwasher, and bushing.
5
Install field coil on armature.
6
Install armature assembly in starter housing.
CAUTION
Use care when installing housing on armature assembly, to prevent damage to windings .
7
Install armature housing over armature assembly.
8
Install five screws.
9
Install five flatwashers on armature.
10
Install brushes in brush holders. Install bolts.
11
Install electrical leads.
12
Install cover on starter assembly. Install two flatwashers, lockwashers, and nuts.
13
Install solenoid. Install two flatwashers, lockwashers and nuts.
14
Install terminal on solenoid. Install flatwasher, starwasher, and nut.
15
Install starter (para 2-31).
3-15