TM 10-4610-229-24
3-49. ALTERNATOR REPAIR (CONT)
g.
Assembly
NOTE
As components are installed, connect leads and remove tags.
1
Install field coil. Torque screws to 55 in. lb.
2
Install rectifier bridge and capacitor.
3
Install regulator and diode trio.
4
Press seal in front housing with lip facing inside of housing.
5
Press seal in retainer plate with lip facing toward bearing.
6
Press bearings into front housing.
7
Install large collar.
8
Fill retainer plate cavity half way with grease.
9
Install gasket on retainer plate.
10
Install retainer plate assembly. Install four bolts.
11
Install small collar in front seal.
12
Install front housing assembly on rotor shaft.
13
Press rear bearing in rear housing.
14
Lubricate bearing with grease.
15
Press on field coil bearings.
16
Install field coil on rear housing with mounting bolts.
17
Press in bearing well plug.
18
Install front housing and rotor assembly in rear housing. Install four thru bolts.
19
Install duct cover.
20
Install fan, pulley, washer, and nut.
21
Using socket-head screw key, keep shaft from turning. Tighten nut.
3-121