TM 10-4610-229-24 2-19.  WIRING HARNESS REPLACEMENT/REPAIR (CONT) WARNING To prevent electric shock, make sure battery is disconnected before performing this procedure. NOTE * Repair of wiring harness consists of replacement of defective wires. * Replacement of wiring harness consists of replacement of all wires. 1 Tag defective wires and desolder as required.  Remove from wiring harness. 2 Cut correct length from bulk wire.  (See schematic above and table below.) If needed, crimp terminal to end of wire. NOTE Wires 16, 17, and 18 are part of the generator. Wire Wire Location Wire Length Number From To In. Wire Gage 1 S3 S5 39.0 14 2 S2 SS1 27.0 14 3 A S1 4.25 14 4 S1 REG5 10.0 14 5 A SS1 24.0 14 6 F FT 42.25 14 7 REG5 REG4 1.0 14 8 S3 0 5.75 16 9 S3 T 9.25 16 10 S3 S2 5.25 16 11 S3 S1 7.75 16 12 S1 F 4.0 16 13 S1 S4 7.0 16 14 S4 DL 4.75 16 15 D1 L1 5.5 14 19 S5 El 7.0 14 3 Install wire in wiring harness.  Solder if required.  Remove tags. 4 Connect battery (para 2-16). 2-59