TM 10-4610-232-12
(g)
Connect the raw water pump discharge hoses (6) to the separators.
(h)
Finish the installation by directing the separator drain hoses (7) away toward the water source.
(i)
Install the 450 raw water inlet adapter (8, Figure 2-27) at the raw water inlet connection on the ROWPU van.
(j)
Lay out and connect raw water hose sections (11, Figure 2-27) between the separator manifold (5, Figure 2-29)
and the raw water inlet adapter. Use only the number of hoses sections needed. Avoid kinking.
NOTE
Steps (k) through (p) apply to Model ROWPU-1 only.
(k)
Install the 90º raw water inlet adapter (8, Figure 2-27) at the raw water inlet connection on the ROWPU van.
NOTE
Do not set separator in front of booster access door.
(I)
Install the cyclone separator (9, Figure 2-29)) into the stake pocket (10) on the trailer.
(m)
Install pipe section (15) onto the cyclone separator (9).
(n)
Connect the raw water discharge pump hose (12) to the cyclone separator (9).
(o)
Connect the raw water inlet hose (11) to the raw water inlet (14) and to the pipe section (15).
(p)
Direct the cyclone separator drain hose (13) toward the water source.
Figure 2-29. Set-Up Cyclone Separator (Sheet 2 of 2)
(MODEL ROWPU-1 ONLY)
Change 12 2-60.1/(2-60.2 Blank)
