TM 10-4610-232-34
(8)
Remove two nuts (46), two brackets (47) and remove REVERSE OSMOSIS SYSTEM PRESSURE gage
(32) from panel (48).
(9)
Remove three screws (50), three self-locking nuts (51), six washers (52), and hinge (53) from plate (48).
b.
Disassemble Panel B as follows:
NOTE
Disassembly of CARTRIDGE INLET/OUTLET PRESSURE gage and MEDIA
INLET/OUTLET PRESSURE gage is the same.
(1)
Remove two valves (61), two nipples (62), two tees (63), and two tees (17) from gage (59).
(2)
Remove bezel (54) to gain access to screws (55).
(3)
Remove three slotted screws (55), three nuts (56), three lock washers (57), and three flat washers (58).
(4)
Remove gage (59) from panel (60).
(5)
Remove three screws (64), three self-locking nuts (65), six washers (66), and hinge (67) from plate (60).
REPAIR.
a.
Check gage with dead weight tester and replace, if necessary.
b.
Replace worn or leaking components.
REASSEMBLY.
NOTE
Apply antiseize tape to pipe threads before assembling components.
a.
Assemble Panel B as follows:
NOTE
Assembly
of
CARTRIDGE
INLET/OUTLET
PRESSURE
gage
and
MEDIA
INLET/OUTLET PRESSURE gage is the same.
(1)
Install hinge (67) with three screws (64), three self-locking nuts (65), and six washers (66).
(2)
Install gage (59) in panel (60) and secure with three slotted screws (55), three nuts (56), three lock washers
(57), and three flat washers (58).
(3)
Mount bezel (54) on front of gage (59).
(4)
Install two tees (63), two nipples (62), two valves (61), and two tees (17) on gage (59).
b.
Reassemble Panel A as follows:
(1)
Install hinge (53) with three screws (50), three self-locking nuts (51), and six washers (52).
(2)
Install REVERSE OSMOSIS SYSTEM PRESSURE gage (32) in panel (48). Secure with two brackets (47)
and two nuts (46).
(3)
Install PRODUCT WATER PRESSURE gage (42) in panel (49). Secure with two brackets (41) and two
nuts (40).
(4)
Install fitting (49) on REVERSE OSMOSIS SYSTEM PRESSURE gage (32).
(5)
Install tee (45), nipple (44), valve (43), and tee (4) on PRODUCT WATER PRESSURE gage (42).
(6)
Install tee (39) in street elbow (38).
(7)
Install street elbow (38), fitting (37), and elbow (36) on selector switch (2).
(8)
Mount selector switch (2) on panel (48) and secure with nut (35).
(9)
Install handle (34) and secure with setscrew (33).
Change 5 2-112.3
