REPAIR. - TM-10-4610-232-34

Figure 2-21. Pressure Gages and Assemblies

TM-10-4610-232-34 Water Purification Unit Reverse Osmosis 3 000 GPH Trailer Mounted Flatbed Cargo 22-1/2 Ton 8 Wheel Tandem Model No. WTA-060 Manual
Page Navigation
116

TM 10-4610-232-34 (8) Remove two nuts (41), two brackets (42) and remove high pressure gage (30) from panel (43). (9) Remove fitting (44) from high pressure gage (30). (10) Remove three screws (45) and self-locking nuts (46), six washers (47) and remove hinge (48) from plate (43). b. Disassemble Panel B as follows: NOTE Disassembly of cartridge filter differential pressure gage and media filter differential pressure gages are the same. (1) Remove bezel (49) to gain access to screws (50). (2) Remove three screws (50), nuts (51), Iockwashers (52), and washers (53). (3) Remove gage (54) from panel (55). (4) Remove tees (17) from gages (54). (5) Remove three screws (56), self-locking nuts (57), six washers (58) and remove hinge (59) from plate (55). REPAIR. a. Check gage with dead weight tester and replace, if necessary. b. Replace worn or leaking components. REASSEMBLY. NOTE Apply antiseize tape to pipe threads before assembling components. a. Assemble Panel B as follows: (1) Install hinge (59) with three screws (56), self-locking nuts (57) and six washers (58). (2) Install tees (17) on gages (54). (3) Install gages (54) in panel (55) and secure with screws (50), nuts (51), Iockwashers (52) and washers (53). (4) Mount bezel (49) on front of gage (54). b. Reassemble Panel A as follows: (1) Install hinge (48) with three screws (45), self-locking nuts (46) and six washers (47). (2) Install fitting (44) on high pressure gage (30). (3) Install high pressure gage (30) in panel (43). Secure with two brackets (42) and nuts (41). (4) Install tee (4) on product gage (40). (5) Install product gage (40) in panel (43). Secure with two brackets (39) and nuts (38). (6) Install tee (37) in street elbow (36). (7) Install street elbow (36), fitting (35) and elbow (34) on selector switch (2). (8) Mount selector switch (2) on panel (43) and secure with nut (33). (9) Install handle (32) and secure with setscrew (33). (10) Mount stainless steel tubing (29) on gage (30) and selector switch (2). 2-111

Privacy Statement
Press Release
Contact