TM 10-4610-232-34
Figure 2-33. Motor Starter MS8-1M
(3) Remove time delay contact (6) from the balance of the motor starter (1 7).
(4) Loosen four captive screws (3) and remove coil cover (7).
(5) Remove coil (8) and pole piece (9).
(6) Loosen two captive screws (1 0) and remove contact cover(11 ).
(7) Remove moveable contact assembly (1 2).
(8) Press down on moveable contacts(13) and remove springs (14) and contacts (1 3).
(9) Remove two screws (15) and overload heater (16).
1. Refer to Figure 2-34 and disassemble motor starters MS8-1S and MS8-2M as follows:
(1) Loosen captive screws (1) and press down and snap out auxiliary contact (2).
(2) Remove four captive screws (1) and remove coil cover (3).
(3) Remove coil (4) and pole piece (5).
(4) Loosen two captive screws (6) and remove contact cover (7).
(5) Remove moveable contact assembly (8).
(6) Press down on moveable contacts (9) and remove springs (1 0) and contacts (9).
(7) Loosen captive screws (11 ), press down and snap out auxiliary contacts(12, 13 and 14).
2-137
